AYLOR ENGINEERING
Building Hi Performance Racing Kawasaki Triples since 1978

690 Polaris Blvd. SE
Rio Rancho, New Mexico 87124
(505) 896-4699
(505) 410-8064 (mobile)
 johnayleng@aol.com

 

Bigazz "Round"
 Price......... $159USD

This seat has been test fitted on all the Kawasaki "triples", and fits the 69-72 H1 500's without frame mods, but frame mods will be necessary on the other models due to the funky rear frame tubing for the tail sections. It has also been test fitted to the RD's and FT 500 Honda. And looks pretty cool if I say so myself!

I designed in a small "flat" at the back for a single LED tail light for a "clean" look. 

I call these fiberglass cafe seat/tail sections "Bigazz". They are designed to be a bit more "comfortable" for us "older" cafe bike builders.  A lot of "cafe" seats out there are not very wide, thus, not very comfortable. The Bigazz seat sections are over 11" wide at the back of the seat for "BIGAZZ" comfort. There is enough area in the tail section to fit a small battery, oil tank (2 strokes) or other accessories.  The sides are a bit deeper so a "era" cool custom snap on seat cover will fit.  Construction is a "easy sand" semi-flexible coating over 2 layers of aircraft quality 1.5 oz. matt fiberglass. Over lapped matting in high stress areas.  The standard finishing and primering is required as in most "raw" fiberglass parts.

 NO mounting hardware, or seat pad is supplied.

 Handling is $5.00 and the shipping will be actual cost. USPS is preferred.

Ride hard, ride fast, look cool.......

 Nothing is better than your buddies seeing your BIGAZZ pass em!

 

H1R "replica" seat/tailsection
Price......... $149USD

 This seat is taken off of a actual H1R seat and then widened to fit all the stock street triple frames. Some frame mods are required.

Construction is also "easy sand" semi-flexible coating over 2 layers of aircraft quality 1.5 oz. matt fiberglass. Over lapped matting in high stress areas.

 The standard finishing and primering is required as in most "raw" fiberglass parts.

 NO mounting hardware, or seat pad is supplied.

 Handling is $5.00 and the shipping will be actual cost. USPS is preferred.

 

Razorback
Price......... $149USD
 It is not as wide as my Big-Azz tail sections. It's pretty darn "mean" lookin.....

Here it is on one of Mark Hasses RD. I think it would look great on the triples too!

 

Home