Index Back Next
CLARIFICATION: Page 60, Water Pump, Assembly, para 1. This should have been written as: Before inserting the water pump holder into the cavity in the crankcase, apply a light coating of transmission lubricant to the o-rings on the outside of the holder body. Pay particular attention when inserting the holder that the coolant inlet hole in the holder body is aligned correctly with the appropriate hole in the crankcase casting. Note that the upper rim of the holder casting has a notch in it to mate with an indexing screw (item 6, figs. 7-10 & 7-14) protruding into the holder cavity thus insuring correct holder orientation. A slight back and forth twisting motion will help during installation of the holder body into the cavity.